Westinghouse Bj505s R Manual Tutorial

To change the seal the easiest way is to take the front of the appliance off. Remove the kick plate at bottom and you will see some screws holding the front panel on remove these Then open door and remove the screws holding the door lock on and unlip the seal by releasing the clamp on the front. The front should now lift off, if it doesnt then pull out the soap drawer and behind that at the bottom of the drawer is a screw holding the front on remove this then push the front panel down then it will lift off You can now take the clamp holding the seal to the tub off. Fit the new seal, fit the clamp to the seal and tub. From here, rebuilding is the reverse of the strip down.

Feb 18, 2010 . Ok - I will answer my own problem seeing as though I have now fitted it! Remove door (2 screws) 2. There is a tensioned wire loop holding the front part of the boot seal in position. - prize off the plastic cap at the 11 o'clock position, all will become clear and you will be able to remove the wire loop. Remove top of washing machine (2 allen screws behind caps at the front. Remove soap dispenser draw and any screws holding the front control panel and top of the door.

Remove bottom front plinth (just pull it off) underneath are a couple of screws holding the front panel part of the machine, remove these. Remove front of machine giving you access to the steel band which locks the other end of the boot seal in position. Slacken this band right back using a nut-spinner screwdriver. Fundamentals Of Space Systems 2nd Edition here. Pull off the old boot and clean the lip ready for fitting of the new boot. Fit new boot seal using a squirt of washing up liquid as lubricant if needed (mine didn't) to reseat the seal. Refit and tension steel band.